拉力測試

瓷磚拉力測試
在 1 kN - 16 kN 力值範圍內的​瓷磚拉力測試
In-house method TIL-P-001 (鋸切方法或取心方法)

瓷磚膠粘劑拉力測試
在 1 kN - 16 kN 力值範圍內的​瓷磚膠粘劑拉力測試
In-house method TIL-P-002 (鋸切方法或取心方法)

底灰
在 1 kN - 16 kN 力值範圍內的​底灰拉力測試
​In-house method TIL-P-004 (鋸切方法或取心方法)

Pull Off Test

Tile
Pull-off test of tiles in the force of range 1 kN to 16 kN
In-house method TIL-P-001 (saw-cutting method or coring method)

Tile adhesive
Pull-off test of tiles adhesive in the force of range 1 kN to 16 kN
In-house method TIL-P-002 (saw-cutting method or coring method)

Render
Pull-off test of render in the force of range 1 kN to 16 kN
In-house method TIL-P-004 (saw-cutting method or coring method)

修補砂漿拉力測試

​在 1 kN 到 16 kN 的力值範圍內的砂漿在混凝土上的黏結強度 (砂漿的拉脫式T型物)
HKHA MTS (2010) Specification Part D Cl.2.1.15 (方法 1)
​在 1 kN 到 16 kN 的力值範圍內的拉脫式T型物
​​In-house method TIL-P-005 (鋸切方法或取心方法)

Repair Mortar
​
​Bond strength of mortar on concrete (Pull-off tees of mortar) in the force of range 1 kN to 16 kN
HKHA MTS (2010) Specification Part D Cl.2.1.15 (Method 1)
​Pull-off tees of in the force of range 1 kN to 16 kN
​In-house method TIL-P-005 (saw-cutting method or coring method)

檢測/試驗材料之間的黏合力如磚、油、防火材料等等。

Adhesion between inspection / testing materials such as bricks, oil, fireproof materials, etc.

原理：
​
測試時，用環氧樹脂將一塊鋼餅牢固地黏合於準備測試材料的表面上，然後透過拉力測試儀進行拉力試驗，而不同材料之間的最大的拉力參數及應力参數將會被紀錄及計算出來。

Principle:
​
​During the test, a steel disc is firmly bonded to the surface of the material to be tested with epoxy resin, and then a tensile test is performed through a tensile tester, and the maximum tensile parameters and stress parameters between different materials will be recorded and calculated.